Recommended Products
Transfer Case Motor - Cardone (48-205)
Details
Details
- Brand:
- SKU:
48-205
- GTIN: 00082617612272
- UPC: 082617612272
- Description: CARDONE Remanufactured Transfer Case Motors are designed to meet or exceed O.E. performance. Reverse engineering provides insight into how and why the unit originally failed, allowing our engineers to identify and correct original design weaknesses. Each unit is 100% computer tested at three points during the remanufacturing process to ensure reliability. CARDONE is committed to getting your vehicle back to peak performance with our direct-replacement transfer case motors.
Transfer Case Mtr - Condition: Remanufactured
Additional Information
Additional Information
| Brand | CARDONE Reman |
| Connector Gender | Female |
| Connector Quantity | 2 |
| Connector Shape | Rectangle |
| Contains Electronic Components | No |
| Does it require SDS | No |
| E-Waste | Yes |
| FAA_A1 | Do not operate the motor while it is off the transfer case. This can damage the motor and set an error code that must be cleared before the motor will operate again. Shift the transfer case into the position of the motor to install. |
| FAA_A2 | Yes, the transfer case should be manually shifted into the two-wheel drive position at the shift shaft before the installation of the replacement motor. Typically the positions are spring-loaded and can be rotated manually. |
| FAA_A3 | A crescent wrench can be used for this operation. |
| FAA_A4 | The replacement motor drive is factory-set in the 2 wheel drive position. |
| FAA_A5 | This may be caused by a transfer case control module calibration issue. Check for DTC's and calibration version − there may be a software update from the Original Equipment Manufacturer. |
| FAQ_Q1 | The replacement motor drive is in a different position, can I reposition before installing? |
| FAQ_Q2 | Can I install the replacement motor if my Transfer Case motor failed in 4 Wheel Drive Low or High? |
| FAQ_Q3 | What tool can I use to manually shift the transfer case into the two-wheel drive position before I install the replacement motor? |
| FAQ_Q4 | What drivetrain position is the replacement motor drive placed in? |
| FAQ_Q5 | The Service 4WD light is on and/or the 4WD is inoperative. What could cause this condition? |
| FAQ_Q6 | If the motor attempts to shift, but sounds weak, check the front axle lock actuator. If the axle lock does not engage, the motor cannot complete its engagement. |
| Gear of Chain Type | Gear |
| Grade Type | Performance |
| Is Item A Chemical | No |
| Is Or Contains A Battery | No |
| Is Or Contains A Bulb | No |
| Is Prop Sixty Five Affected | No |
| Is the item CARB affected | No |
| Manufacturer Brand | CPCX |
| Mount Type | Direct Bolt |
| Mounting Hardware Included | No |
| Mounting Hole Quantity | 3 |
| Package Contents | Transfer Case Motor; Instruction Sheet |
| Shift Operation Type | Electronic |
| Sprocket Tooth Quantity | 4 |
| Terminal Gender | Male |
| Terminal Quantity | 8 |
| Terminal Type | Blade |
| UPC | 00082617612272 |
| Wiring Harness Included | No |
Related Products
Vehicle Fitment
Vehicle Fitment
Select Your Vehicle Select
| Year | Make | Model | Body & Trim | Engine & Transmission |
|---|