Recommended Products
Disc Brake Caliper - Cardone (19-B2699)
Details
Details
- Brand:
- SKU:
19-B2699
- GTIN: 00082617698795
- UPC: 082617698795
- Positions: Front Right
- Description:
Expertly remanufactured to rigorous quality and performance standards, all CARDONE Brake Calipers are equipped with brand-new, premium components to guarantee exceptional longevity and reliability. These remanufactured brake calipers are 100% pressure-tested to deliver consistent, industry-leading brake performance. Each unit arrives with a complete set of brand-new hardware for a simple, complete installation. Caliper bracket is included when applicable.
- Condition: Remanufactured
Additional Information
Additional Information
| Brand | CARDONE Reman |
| Abutment Clips Included | Yes |
| Anti-Rattle Spring Included | No |
| Bleeder Screw Cap Included | No |
| Bleeder Screw Included | Yes |
| Bleeder Screw Quantity | 1 |
| Bleeder Thread Size | M7x1.0 |
| Bracket Included | Yes |
| Caliper Color | Gray |
| Caliper Finish | Oil Emulsion |
| Caliper Slides Included | Yes |
| Caliper Type | Floating |
| Casting Number | 5723 |
| Contains Electronic Components | No |
| Disc Brake Caliper Casting Material | Cast Iron |
| Does it require SDS | No |
| Dust Boots Included | Yes |
| E-Waste | No |
| FAA_A1 | Not recommended. The O.E. manufacturers specified steel or phenolic pistons based on the intended use of the vehicle. It is recommended that the installer follow the manufacturer’s recommendations. |
| FAA_A2 | As a rule, always use brake fluid recommended by O.E. The fluid type is stamped on the master cylinder reservoir lid. Always use new fluid in a sealed container. |
| FAA_A3 | Inspect both calipers for binding or sticky slides or pins. Also ensure that brake hoses are not collapsed or restricted and inspect steering/suspension components for proper operation. |
| FAA_A4 | Brake squeal can be caused by improper installation of the brake pads, improperly installed brake hardware and improper brake rotor finish. |
| FAA_A5 | A symptom of a low brake pedal is usually caused by air in the system, misadjusted rear brake shoes, deteriorated brake hose(s) or a defective master cylinder. |
| FAA_A6 | A silicone grease is used on floating caliper mounting pins. |
| FAA_A7 | New hardware is included with all of our Calipers however the mounting bracket is an added option depending on part number and application. Mounting Brackets are also sold separately for most applications. |
| FAQ_Q1 | Can I switch out a Phenolic Piston Caliper for a Steel Piston Caliper or vice versa? |
| FAQ_Q2 | What type of fluid should I use: DOT 3, DOT 4, or DOT 5? |
| FAQ_Q3 | Car pulls to one side during braking. Why? |
| FAQ_Q4 | Brakes squeal all of the time. What's causing the squeal? |
| FAQ_Q5 | Could calipers be the cause of a low brake pedal? |
| FAQ_Q6 | What type of grease is used on floating caliper mounting pins? |
| FAQ_Q7 | Do all of your Calipers come with the new hardware and a mounting bracket for installation? |
| Grade Type | Regular |
| Inlet Fitting Type | Banjo |
| Inlet Port Size | 10.00366 |
| Inlet Thread Size | M10x1.0 |
| Is Item A Chemical | No |
| Is Or Contains A Battery | No |
| Is Or Contains A Bulb | No |
| Is Prop Sixty Five Affected | No |
| Is the item CARB affected | No |
| Manufacturer Brand | CPCX |
| Mounting Bolt Included | No |
| Mounting Bracket Included | Yes |
| Mounting Hardware Included | Yes |
| Mounting Hole Diameter | 11.98408 |
| Mounting Hole Thread Diameter | 11.98408 |
| Mounting Hole Thread size | M12x1.25 |
| Package Contents | Caliper; Instruction Sheet; Bracket; Hardware Kit |
| Pad Wear Sensor Included | No |
| Pads Included | No |
| Piston Diameter | 57.04 |
| Piston Material | Steel |
| Piston Quantity | 1 |
| Rust Resistant Coating | Yes |
| UPC | 00082617698795 |
Related Products
Vehicle Fitment
Vehicle Fitment
Select Your Vehicle Select
| Year | Make | Model | Body & Trim | Engine & Transmission |
|---|